Add more adhesive until the cloth is completely saturated. Use the disposable brush in the package to wet the fiberglass cloth with the adhesive. Now you can squeeze some of the epoxy out onto the cloth. Squeeze the pouch until the two halves rupture their divider, then agitate them together for 30 seconds or so. There's also a pouch of epoxy in the package. Now do a final degreasing with rubbing alcohol or lacquer thinner, and don't touch the surface again. Rough up the surface that the cloth will contact with the sandpaper. The kit has a sheet of fiberglass cloth inside, as well as a sheet of sandpaper. Pull the cracked tank out and clean it really well with soap and water-then dry it out thoroughly. Try this DIY fix: Go to the auto parts store and hunt down a Permatex Plastic Tank Repair Kit. That high estimate sounds like somebody really doesn't want to be bothered with pulling out the tank and ferrying it around town to get welded somewhere else. Silicone sealer just doesn't have the adhesive properties or the strength to hold these plastic parts together in the hot, high-vibration area underhood. Those reservoirs are generally made of high-density polyethylene and are fairly easy to weld with conventional plastic-welding techniques. But you already had that figured out, right? Don't forget to spray the washers for a few seconds after filling up, until the blue stuff comes out of the lines and nozzles.Ībout your reservoir, though: A hundred bucks sounds like a lot of money to fix a tank, unless all you have left is a shoebox full of parts. Washer fluid has a high alcohol content and won't freeze. Any suggestions?Ī: First suggestion: Drain and refill the windshield reservoir with fresh washer fluid-not water-in the fall, when you winterize the rest of the RV. Includes: 1x Wiper Washer Fluid Reservoir, w/ pump. The mechanic at the RV dealer across town says he can have it welded, but it would cost over $100. This one is an IH part but no longer has the IH stamped in the plastic. I tried to patch it with silicone sealant and duct tape, but the reservoir always leaks within a few days. The RV dealer near me has gone out of business, so I can't even order another reservoir. I suspect this happened last winter when the year-old water in it froze solid. The tank is usually translucent, allowing you to see whether there is fluid in the reservoir or not. Q: The plastic windshield-washer-fluid reservoir in my RV has a 2-inch-long crack in it. /rebates/2farticle2fis-it-important-to-keep-liquid-in-the-windshield-washer-reservoir&. On most cars, the washer fluid reservoir is located at the back of the engine bay, near the base of the windshield.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |